Commercial Mold Remediation Protocols for Condos

Before any mold removal starts, the pros seal off the affected area with plastic sheeting and use negative air pressure to keep spores from spreading to other units. They also set up a decontamination area for anyone entering or leaving the workspace. This protects you and your neighbors.

Personal protective gear is standard for the workers, but you should stay out of the contained zone until the pros say it is safe. If you feel unwell during or after the work, see a doctor. In Frisco, where the humid subtropical climate with hot summers and spring hail and thunderstorms can promote mold growth, acting quickly is key.

• Plastic sheeting seals doorways and vents
• Negative air machines pull spores out
• Workers wear respirators and suits
• Decontamination chamber for entry and exit
• You stay out of the contained area

After removal, the pros clean all surfaces in the affected area with a HEPA vacuum and wipe down with an antimicrobial solution. They also clean the air by running HEPA filtration to capture any remaining spores.

Disinfecting is not the same as removing mold. The pros first remove the visible mold, then apply a disinfectant to kill any lingering spores. This two-step process is critical for preventing regrowth. Your condo's shared HVAC system may need attention too, so ask the pros about that.

After the cleanup and drying, a separate step is clearance testing. A mold professional takes air and surface samples to confirm the mold levels are back to normal. This step is not always required, but it gives you peace of mind that the work was done right.

Clearance testing is especially important in a condo because mold can affect shared walls and airspace. If the test shows problems, the pros may need to redo some steps. Policies vary, and your insurer decides what is covered. Check your policy to see if testing is included.